Sourcing manual bearing pullers from China

Manual bearing puller duty

Heading 8205 covers hand tools not elsewhere specified, alongside vices, clamps and other listed equipment. For a mechanically operated bearing puller, the other-hand-tools line 8205 59 80 00 is a starting point for classification. The table shows different puller designs against this same provisional line, rather than separate tariff categories.

Read from the UK Trade Tariff on 17 October 2026, the supplied heading data show duties ranging from 0% to 2%; the provisional manual-puller line carries 2% for goods from China. That line lists no anti-dumping or countervailing duty, suspension or attached import control.

Confirm the commodity code using drawings, the operating mechanism and the complete contents of any kit. A puller kit containing other tools needs separate consideration. See the wider hand tool sets guide for mixed-tool classification.

Specify the grip and pulling mechanism

Specify external or internal grip, jaw opening, usable reach, hook thickness and clearance behind the bearing. Supply drawings of the intended bearing and shaft arrangement. State whether jaws must reverse, how they are retained and which separators or adaptors are included.

Agree steel grades, heat treatment, screw thread geometry, spindle tip shape and lubrication instructions. Tie any claimed pulling capacity to an agreed test fixture and acceptance criteria. Request a demonstration on the intended arrangement, including inspection for permanent deformation after unloading.

Pullers intended for, or reasonably likely to be used by, consumers fall within the General Product Safety Regulations 2005 in Great Britain. As purchasing specifications, request clear instructions covering seating the jaws, centring the spindle, lubrication and stopping if the tool slips or distorts.

Worked duty example

Illustrative example, not a quote: Illustrative batch of cased manual bearing pullers under 8205 59 80 00, invoiced at £4,000 free on board, with £2,000 of freight and insurance to the UK. The customs value is £6,000. Duty at 2% is £120. Import VAT at 20% is charged on the customs value plus duty, £6,120, so it is £1,224. Import taxes total £1,344; a VAT-registered importer can usually reclaim the VAT, so the lasting cost is the £120 of duty. The import duty and VAT guide explains each step.

Inspection checklist

Grip and reach: measure usable opening, reach and hook thickness against the drawing; check that jaws seat behind the intended bearing without fouling adjacent parts.

Spindle and joints: run the screw through its travel; inspect threads, tip alignment, pivot pins and retaining hardware for binding, looseness and burrs.

Load performance: use the agreed fixture and test procedure; check for jaw slip, bent arms, damaged threads and permanent distortion after unloading.

Arrival and packing: count jaws, separators and adaptors; inspect for corrosion and transit damage; confirm that instructions and case contents match the approved sample.

What goes wrong

A puller can match the advertised opening yet fail to reach behind a recessed bearing. Thick hooks foul neighbouring parts, shallow hooks slip, and an off-centre spindle pushes sideways. Approve fit on the intended assembly before accepting the production design.

Poor heat treatment can leave jaws prone to bending or fracture. Rough threads bind under load, spindle tips damage shaft ends, and loose pivots let the jaws spread. Agree fit and load checks before production, then compare delivered goods with the approved sample.

Cambridge China Bridge sources these products for UK businesses, checking the factory and the documents before shipment. See factory verification. For repeat volumes, see container programmes.